LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 665 (Automatic Transmission - 4R100 - Excursion & F250-F550 Super Duty) >> Disassembly & Assembly Of Subassemblies >> Output Shaft - Check >> Assembly

Output Shaft - Check: Assembly

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: If any damage is found to the output shaft drive sprocket speed sensor wheel, a new output shaft drive sprocket speed sensor wheel will need to be installed.
    Fig 1: Removing Use Arbor Press And Special Tool-Install Park Gear
    G02775295Courtesy of FORD MOTOR CO.
  1. If removed, use the arbor press and the special tool to install the park gear. Press the park gear onto the output shaft until it stops at the shoulder on the output shaft.
  2. If removed, install the output shaft drive sprocket speed sensor wheel using the special tool.
    Fig 2: Installing Output Shaft Drive Sprocket Speed Sensor Wheel
    G02775296Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals