LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 663 (Electronic Engine Controls - Gasoline Engine -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Clutch Pedal Position (CPP) Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. Refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the electrical connector from the clutch pedal position (CPP) switch.
    Fig 1: Disconnecting Electrical Connector From Clutch Pedal Position (CPP) Switch
    G02773444Courtesy of FORD MOTOR CO.
  3. Release the CPP from the orientation clip.
    Fig 2: Releasing CPP From Orientation Clip
    G02773445Courtesy of FORD MOTOR CO.
  4. Remove the plastic retainer.
    1. Push the lock tabs together.
    2. Slide the plastic retainer off the CPP switch.
    Fig 3: Removing Plastic Retainer
    G02773446Courtesy of FORD MOTOR CO.
  5. Remove the CPP switch.
    Fig 4: Removing CPP Switch
    G02773447Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals