LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 652 (Engine System - General Information - Excursion & F250-F550 Super Duty (Gasoline)) >> General Procedures >> Connecting Rod - Large End Bore

Connecting Rod - Large End Bore

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the bolts to specification, then measure the bore in two directions. The difference is the connecting rod bore out-of-round. Verify the out-of-round is within specification.
    • If out of specification, install new components as necessary.
      Fig 1: Measuring Connecting Rod - Large End Bore
      G02770377Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals