Key On Engine Off (KOEO) Self-Test

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2003 Mazda B4000, 2003 Mazda B3000, 2003 Mazda B2300, 2002 Mazda B4000, and 2002 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.

These DTCs indicate faults are present at time of testing. A hard fault may cause CHECK ENGINE or MIL to illuminate and remain illuminated until fault is repaired. If KOEO DTCs are retrieved during a KOEO SELF-TEST, identify DTCs and perform appropriate diagnostic test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .

SYSTEM PASS codes indicates no DTCs were recorded in that portion of test. If SYSTEM PASS is not retrieved in KOEO SELF-TEST, DTCs retrieved during KOER SELF-TEST may not be valid. Ensure engine is at normal operating temperature. If engine does not start (or stalls after starting), continue KOEO SELF-TEST. Turn ignition switch to OFF position. Ensure test equipment is properly attached. Program NGS tester following manufacturer's instructions. Follow operating instructions from NGS tester menu.