LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 65 (Automatic Transmission - Diagnosis - 5R44E & 5R55E) >> Diagnostic Tests >> Test F: Solenoid Mechanical Failure

Test F: Solenoid Mechanical Failure

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2003 Mazda B4000, 2003 Mazda B3000, 2003 Mazda B2300, 2002 Mazda B4000, and 2002 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: All other DTCs must be repaired and cleared prior to repairing DTCs P1714, P1715, P1716, P1717 or P1740.
NOTE: After each service or repair procedure has been completed, reconnect all components. Clear DTCs and repeat QUICK TEST. See RETRIEVING DIAGNOSTIC TROUBLE CODES (QUICK TEST)  under SELF-DIAGNOSTIC SYSTEM. Ensure all EEC-V systems are working properly and DTCs are no longer present.
  1. Connect NGS tester to DLC. Place gearshift lever in "P" position. Turn ignition switch to ON position. Perform KEY ON ENGINE OFF SELF-TEST until continuous memory codes are displayed. See RETRIEVING DIAGNOSTIC TROUBLE CODES (QUICK TEST)  under SELF-DIAGNOSTIC SYSTEM. If any DTCs for TFT sensor or shift solenoids are present, repair them first. Clear DTCs. See CLEARING DIAGNOSTIC TROUBLE CODES  under SELF-DIAGNOSTIC SYSTEM. Repeat RETRIEVING DIAGNOSTIC TROUBLE CODES (QUICK TEST) . If only DTCs P1714, P1715, P1716, P1717 or P1740 are set, replace suspect solenoid relating to DTC and go to next step.
  2. Perform TRANSMISSION DRIVE CYCLE TEST  under SELF-DIAGNOSTIC SYSTEM. If transmission up and downshifts normally, go to next step. If transmission does not up or downshift normally, see appropriate symptom in appropriate SYMPTOM DIAGNOSIS under TROUBLE SHOOTING .
  3. Ensure NGS tester is connected to DLC and gearshift lever is in "P" position. Perform KEY ON ENGINE OFF SELF-TEST again until continuous memory codes are displayed. See RETRIEVING DIAGNOSTIC TROUBLE CODES (QUICK TEST)  under SELF-DIAGNOSTIC SYSTEM. If DTCs P1714, P1715, P1716, P1717 or P1740 are still present, replace PCM and perform TRANSMISSION DRIVE CYCLE TEST  under SELF-DIAGNOSTIC SYSTEM. Repeat RETRIEVING DIAGNOSTIC TROUBLE CODES (QUICK TEST) . If DTCs P1714, P1715, P1716, P1717 or P1740 are not set, no shifting problems should exist. If shifting problems still exist, see appropriate symptom in appropriate SYMPTOM DIAGNOSIS under TROUBLE SHOOTING .