LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 639 (Driveshaft -- Excursion & F250-F550 Super Duty) >> Removal And Installation >> Driveshaft - Rear, Three-Piece >> Removal

Driveshaft - Rear, Three-Piece: Removal

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. For additional information, refer to JACKING & LIFTING .
  2. Index-mark the driveshaft at the axle flange.
    Fig 1: Identifying Index-Mark Driveshaft At Axle Flange
    G02768634Courtesy of FORD MOTOR CO.
  3. Disconnect the driveshaft from the axle flange.
    1. Remove and discard the bolts.
    2. Remove and discard the U-joint retainers.
      • Using mechanics wire, support the driveshaft.
    Fig 2: Disconnecting Driveshaft From Axle Flange
    G02768635Courtesy of FORD MOTOR CO.
  4. Disconnect the driveshaft from the coupling shaft.
    1. Remove and discard the bolts.
    2. Remove the U-joint retainers.
      • Using mechanics wire, support the driveshaft.
    Fig 3: Disconnecting Driveshaft From Coupling Shaft
    G03918062Courtesy of FORD MOTOR CO.
  5. Remove the center bearing support bolts.
    Fig 4: Removing Center Bearing Support Bolts
    G03883324Courtesy of FORD MOTOR CO.
  6. Remove the rear driveshaft assembly.
    7. NOTE: Index-mark the driveshaft to transmission flange or output shaft to slip yoke.
    Fig 5: Identifying Marking Index-Mark On Driveshaft Yoke And Transmission Flange
    G03918024Courtesy of FORD MOTOR CO.
  7. For vehicles equipped with a circular flange, remove and discard the bolts.
  8. Remove the center bearing support bolts.
    Fig 6: Removing Center Bearing Support Bolts
    G02768639Courtesy of FORD MOTOR CO.
  9. Remove the front driveshaft.
    • For vehicles equipped with a slip yoke, lower the driveshaft and slide it rearward off the transmission output shaft.
    • Plug the extension housing to prevent fluid loss.
  10. Clean grease deposits, dirt and rust from the following:
    • The driveshaft yoke areas.
    • All driveshaft components.
    • Wipe the bearing and rubber insulator of the driveshaft center bearing. Do not immerse in solvent.
  11. Inspect the following:
    • The universal joint slip yoke boot for rips or holes. Install a new boot if necessary.
    • The driveshaft center bearing support for wear or rough action. If roughness or wear is evident, install a new driveshaft center bearing support.
    • The center bearing rubber insulator for evidence of hardening, cracking or deterioration. Install a new insulator if necessary.
scientia non olet · About LEMON Manuals