Toe Adjustment - F-250, F-350, 4x4 and F-450, F-550

WARNING: This page is about a different car, the 2004 Ford Pickup, 2004 Ford F550 Super Duty, 2004 Ford F450 Super Duty, 2004 Ford Excursion, and 2004 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Start the engine. Center the steering wheel.

Fig 1: Identifying Steering
Courtesy of FORD MOTOR CO.
Turn the engine off. Use a rigid link from the steering wheel to the brake pedal to lock the steering wheel in the straight-forward position.

NOTE: If the RH toe measurement is within specifications and only the LH toe measurement needs adjustment, go to Step 6.

Loosen the nuts.
- Clean and lubricate the steering linkage and tie rod end threads.
  
  Fig 2: Identifying Nut
  Courtesy of FORD MOTOR CO.
Rotate the tie rod adjusting sleeve to the correct toe setting.

Fig 3: Rotating Tie Rod Adjusting Sleeve To Correct Toe Setting
Courtesy of FORD MOTOR CO.
Tighten the nuts.

Fig 4: Tightening Nuts
Courtesy of FORD MOTOR CO.
Loosen the nuts.
- Clean and lubricate the steering linkage and tie rod end threads.
  
  Fig 5: Locating Bolt
  Courtesy of FORD MOTOR CO.
Rotate the tie rod adjusting sleeve to the correct toe setting.

Fig 6: Rotating Tie Rod Adjusting Sleeve To Correct Toe Setting
Courtesy of FORD MOTOR CO.
Tighten the nuts.

Fig 7: Tightening Nuts
Courtesy of FORD MOTOR CO.
Recheck the toe settings. Follow the manufacturer's instructions.