LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 633 (Safety Belt System) >> Removal And Installation >> Retractor - Rear Safety Belt and Tongue >> Removal

Retractor - Rear Safety Belt and Tongue: Removal

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or if it does not remain closed, install a new shoulder safety belt guide.
    Fig 1: Removing Shoulder Safety Belt Guide
    G02767497Courtesy of FORD MOTOR CO.
  1. On a rear safety belt retractor and tongue (611B68) with a flip-up shoulder safety belt guide cover, remove the shoulder safety belt guide as follows.
    1. Lift the shoulder safety belt guide cover.
    2. Use the Safety Belt Bolt Torx Bit to remove the bolt.
    3. Remove the shoulder safety belt guide.
    2. NOTE: Inspect the shoulder safety belt guide cover for damage. If the shoulder safety belt guide cover is damaged or if it does not remain closed, install a new shoulder safety belt guide.
    Fig 2: Removing Shoulder Safety Belt Guide
    G02767498Courtesy of FORD MOTOR CO.
  2. On a rear safety belt retractor and tongue without a flip-up shoulder safety belt guide cover, remove the shoulder safety belt guide as follows.
    1. Position the shoulder safety belt cover aside.
    2. Use the Safety Belt Bolt Torx Bit to remove the bolt.
    3. Remove the shoulder safety belt guide.
  3. On the LH second row rear safety belt retractor and tongue, remove the quarter trim finish panel (311A59), the body side rear center lower trim panel (31025) and the quarter trim panel (31013). For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  4. On the LH third, fourth and fifth row rear safety belt retractor and tongues, remove the quarter trim rear upper panel and the quarter trim rear lower panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  5. On the RH rear safety belt retractor and tongue, remove the quarter trim upper panel, the quarter trim lower panel, the quarter trim rear upper panel and the body side trim cover rear. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  6. Remove the safety belt retractor.
    1. Remove the shoulder safety belt guide.
    2. Use the Safety Belt Bolt Torx Bit to remove the bolt.
    3. Remove the safety belt retractor.
    Fig 3: Removing Safety Belt Retractor
    G02767499Courtesy of FORD MOTOR CO.
  7. On a rear safety belt retractor and tongue with a detachable safety belt anchor, disengage the detachable safety belt anchor.
    1. Insert a key or small screwdriver into the slot in the detachable anchor and lift upward.
    2. Disengage the detachable anchor tongue end from the detachable anchor.
    Fig 4: Disengaging The Detachable Anchor Tongue End From The Detachable Anchor
    G02767500Courtesy of FORD MOTOR CO.
  8. On a rear safety belt retractor and tongue without a detachable safety belt anchor, remove the safety belt anchor.
    1. Use the Safety Belt Bolt Torx Bit to remove the bolt.
    2. Remove the safety belt anchor.
    Fig 5: Removing Safety Belt Anchor
    G02767501Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals