Safety Belt Shoulder Height Adjuster With Stripped Weld Nuts

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

SPECIAL TOOL(S)

Fig 1: Identifying Special Tool

Courtesy of FORD MOTOR CO.

Remove the shoulder safety belt height adjuster (602B82). For additional information, refer to HEIGHT ADJUSTER - SHOULDER SAFETY BELT .
Use the half-inch drill with integral stop provided in the D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.

Fig 2: Installing D-Ring
Courtesy of FORD MOTOR CO.

NOTE: After each rotation, back off the tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.

Fig 3: Applying Suitable Lubricant Provided In D-Ring Installation Kit

Courtesy of FORD MOTOR CO.

Apply a suitable lubricant to the M14 x 1.5 tap with integral stop provided in the D-Ring Installation Kit, and tap new threads.
Use a threaded insert (part no. N807170-S190) provided in the D-Ring Installation Kit and screw it into the retapped hole until it is slightly below the surface.

Fig 4: Installing Kit And Screw It Into The Retapped Hole
Courtesy of FORD MOTOR CO.
Use a hammer to lightly tap the installation tool provided in the D-Ring Installation Kit several times to seat the insert keys.

Fig 5: Installing Tool Provided In The D-Ring
Courtesy of FORD MOTOR CO.

NOTE: If the shoulder safety belt height adjuster retaining bolts are stripped, install a new shoulder safety belt height adjuster and retaining bolts. For additional information, refer to the Ford/Lincoln Mercury Master Parts Catalog for the appropriate parts.

Install the shoulder safety belt height adjuster. For additional information, refer to HEIGHT ADJUSTER - SHOULDER SAFETY BELT .