Child Safety Seat - Tether Attachment
WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Some manufacturers make safety seats with a tether strap that goes over the back of the vehicle seat and attaches to an anchoring point behind the seat.
Ford recommends the placement of tethered safety seats in a rear seating position, with the tether strap attached to the tether anchoring point. The right front seating position can be used if it is the only seating position available. The tether anchor attachment point for the right front seating position is located on the rear edge of the seat. For additional information, refer to the vehicle owner guide for installation instructions.