LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 631 (Wiper System And Washer System) >> Removal And Installation >> Pivot Arm >> Removal

Pivot Arm: Removal

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The windshield wiper pivot arm (17526) can be removed at any point in the wiper sweep without the use of tools.
  1. Release the pivot arm locking lever.
    1. Carefully raise the windshield wiper blade away from the windshield glass (03100) until it stops.
    2. Pull the locking lever away from the windshield wiper pivot arm.
    Fig 1: Pulling Locking Lever Away From Windshield Wiper Pivot Arm
    G02767448Courtesy of FORD MOTOR CO.
  2. Lift the windshield wiper pivot arm from the windshield wiper mounting arm and pivot shaft (17566).
    Fig 2: Lifting Windshield Wiper Pivot Arm From Windshield Wiper Mounting Arm And Pivot Shaft
    G02767449Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals