LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 63 (Starting System - Starters - Except Diesel) >> Component Tests >> Starter No-Load Test

Starter No-Load Test

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, 2004 Ford Cutaway, and 2003 Ford RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Ensure starter motor is securely mounted on bench as starter motor may move or jump when energized.
  1. Remove starter motor. See STARTER MOTOR  under REMOVAL & INSTALLATION. Connect remote starter switch between positive battery terminal and starter motor solenoid terminal "S". See Figure. Jumper starter motor "B" terminal to positive battery post. Connect charging/starting system tester according to manufacturer's instructions. Ensure battery and starter motor are grounded.
  2. Engage remote starter switch. Starter should eject starter drive and turn smoothly. DVOM should indicate 11 volts or more, and ammeter should indicate 70 amps. If voltage is lower or current is higher than specification, replace starter motor. See STARTER MOTOR  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals