Starter No-Load Test
WARNING: This page is about a different car, the 2002 Ford RV Cutaway, 2002 Ford Econoline, 2002 Ford E550 Super Duty, 2002 Ford E450 Super Duty, and 2002 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Remove starter from vehicle. See STARTER MOTOR under REMOVAL & INSTALLATION. Connect a fully charged battery to starter. Connect Alternator, Regulator, Battery and Starter Tester (ARBST). Connect a remote starter switch between starter solenoid terminal "S" and positive battery terminal post. Press remote starter switch. Pinion should shift to crank position and motor should run smoothly. While starter motor is running, record DVOM and ammeter readings. DVOM should indicate 11 volts or more, and ammeter should indicate no more than 170 amps. If voltage is lower or current is higher than specification, replace or overhaul starter.