LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 619 (Exterior Lighting) >> Removal And Installation >> Lamp Switch - Brake Pedal Position >> Removal

Lamp Switch - Brake Pedal Position: Removal

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the brake pedal position (BPP) switch electrical connector.
    Fig 1: Disconnecting Brake Pedal Position Switch Electrical Connector
    G02766855Courtesy of FORD MOTOR CO.
  3. Remove the BPP switch.
    1. Remove the self-locking pin.
    2. Remove the brake master cylinder push rod spacer.
    3. Remove the BPP switch from the brake master cylinder push rod.
    4. Remove the brake master cylinder push rod bushing.
    5. Remove the brake master cylinder push rod spacer.
    Fig 2: Removing BPP Switch
    G02766856Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals