Speaker Walk-Around Test
WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The audio unit must be turned ON and in radio tuner mode (AM/FM) to enter the speaker walk-around test.
- To enter the speaker walk-around test, press preset buttons 3 and 6 (1 and 4 for ULC only) simultaneously and hold for approximately three seconds, then release.
- The speaker walk-around test applies sound to each speaker for about 1-2 seconds. Each speaker is tested and shown on the display in the following sequence: RF, LF, LR, RR.
- The speaker walk-around test automatically continues and tests. If the vehicle is not equipped with CD/DJ or if the CD/DJ is not responding, NO DJ will be displayed. To exit speaker walk-around test, turn the ignition switch OFF, turn the audio unit OFF, or preset button 1 for "DIA".