LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 604 (Fuel System-General Information-Gasoline & Diesel) >> General Procedures >> Push Connect Fittings >> Disconnect

Push Connect Fittings: Disconnect

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and can be ignited, resulting in possible personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is not running. Before repairing or disconnecting any of the fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel, causing personal injury or a fire hazard.
  1. Release the fuel pressure. For additional information, refer to FUEL SYSTEM PRESSURE RELEASE - GASOLINE ENGINES  or FUEL SYSTEM PRESSURE RELEASE - DIESEL ENGINES .
  2. Disconnect the safety clip from the male hose.
    Fig 1: Disconnecting Safety Clip From Male Hose
    G02765971Courtesy of FORD MOTOR CO.
  3. Install the fuel tube disconnect tool and push into the fittings.
    Fig 2: Installing Fuel Tube Disconnecting Tool And Push Into Fittings
    G02765972Courtesy of FORD MOTOR CO.
  4. Separate the fittings.
    • Inspect for damage.
    • Clean the fittings.
    Fig 3: Separating Fittings
    G02765973Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals