DRIVE MODE Procedure for GR_CM

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

Follow operating instructions from the scan tool menu screen.

Select "Output State Control."
Select "Trans - DRIVE MODE."
Select "PIDs" to be monitored.
Monitor all selected PIDs during test.
Select "Parameters - GR_CM."
Select Value "1-4."
Press "SEND" to send command.
Re-Select Value "1-4."
Press "SEND" to send command.
Select "XXX" to cancel at any time.
Press "SEND."