LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 597 (Electronic Engine Controls- Gasoline Engines) >> Removal And Installation >> Engine Coolant Temperature (ECT) Sensor - 6.8L >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Partially drain the cooling system. For additional information, refer to ENGINE COOLING .
  3. Remove the engine coolant temperature (ECT) sensor.
    1. Disconnect the connector.
    2. Remove the ECT sensor.
    Fig 1: Removing ECT Sensor
    G02761801Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals