LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 596 (Evaporative Emissions) >> General Procedures >> Evaporative Emission System Leak Test >> Phase 1 - Leak Verification

Phase 1 - Leak Verification

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the Rotunda Smoke Machine Leak Tester to the evaporative emission (EVAP) test port.
  2. Close the canister vent solenoid. For additional information, refer to CANISTER VENT SOLENOID CLOSING PROCEDURE .
  3. Using the Rotunda Smoke Machine, pressurize the EVAP system.
  4. Monitor the indicator flag on the Smoke Machine Tester. If the measurement is below the indicator flag, the system has passed the leak test and the test procedure is complete. If the measurement is above the indicator flag the system has failed the leak test. Proceed to Phase 2.
scientia non olet · About LEMON Manuals