Removal and Installation

WARNING: This page is about a different car, the 2004 Ford RV Cutaway, 2004 Ford Econoline, 2004 Ford E450 Super Duty, and 2004 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.

With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
Remove the nuts.

Fig 1: Removing Nuts
Courtesy of FORD MOTOR CO.

NOTE: During installation tighten the exhaust manifold nuts in the sequence shown.

Fig 2: Exhaust Manifold Nut Tightening Sequence

Courtesy of FORD MOTOR CO.

Remove the exhaust manifold nuts and the exhaust manifold.
- Discard the exhaust manifold gaskets.
Clean and inspect the exhaust manifold. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION .
To install, reverse the removal procedure.