LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 571 (Safety Belt System) >> General Procedures >> Safety Belt With Anchor Plate Thread Damage

Safety Belt With Anchor Plate Thread Damage

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the broken or stripped bolt and discard.
  2. Drill out the internal threads in the safety belt anchor plate with a 10.7 mm (27/64 in) drill.
  3. Rethread the anchor plate with a 1/2-13 tap (seat belt).
  4. Clean out the chips.
  5. Install the attachment parts. Original parts are to be replaced with the repair parts indicated in the Safety Belt Parts Replacement Guidelines.
  6. When repairing a multiple belt and attachment, install the nut to the bolt in the tunnel area from the underside of the floorpan.
scientia non olet · About LEMON Manuals