LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 563 (Exterior Lighting System) >> Removal And Installation >> Side Turn Signal Lamp

Side Turn Signal Lamp

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: RH shown, LH similar.
Fig 1: Removing Side Turn Signal Lamp
G03945711Courtesy of FORD MOTOR CO.
  1. Remove the headlamp. For additional information, refer to HEADLAMP ASSEMBLY .
  2. Remove the turn signal lamp screw.
  3. Disconnect the electrical connector.
  4. Remove the turn signal lamp assembly.
  5. To install, reverse the removal procedure.