Transmission Fluid Drain and Refill - Automated Equipment: Refill

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.

Use only clean automatic transmission fluid.
Once the fluid exchange has been completed, disconnect the flush and fill machine. Reconnect any disconnected fluid cooler tubes.
Lower the vehicle. For additional information, refer to JACKING & LIFTING .
With the engine running, check and adjust the transmission fluid level and check for any leaks. If fluid is needed, add fluid in increments of 0.24-liter (0.5-pint) until the correct level is achieved. For additional information, refer to TRANSMISSION FLUID LEVEL CHECK .