LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 556 (Automatic Transmission) >> Disassembly And Assembly Of Subassemblies >> Reverse Servo Assembly >> Item 4: Reverse Servo Plate Disassembly Note

Item 4: Reverse Servo Plate Disassembly Note

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: The upper and lower servo covers are under spring tension. Use care when separating the two halves. Failure to follow these instructions may result in personal injury.
    NOTE: Tabs on servo plate mate with slots on cover every 120 degrees.
    Fig 1: Aligning Arrow On Servo Plate With Any Slot On Cover
    G03182252Courtesy of FORD MOTOR CO.
  1. Remove the reverse servo plate by turning in either direction to release.
    • Align the arrow on the servo plate with any slot on the cover.
scientia non olet · About LEMON Manuals