LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 556 (Automatic Transmission) >> Disassembly And Assembly Of Subassemblies >> Overdrive Brake and Coast Clutch Drum Assembly >> Item 8: Direct and Overdrive Clutch Piston Disassembly Note

Item 8: Direct and Overdrive Clutch Piston Disassembly Note

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Air pressure must not exceed 138 kPa (20 psi). Wear safety glasses when using compressed air, and make sure the drum is facing down as shown. Failure to follow these instructions may result in personal injury.
    Fig 1: Locating Hole In Drum
    G03182201Courtesy of FORD MOTOR CO.
  1. Remove the coast clutch piston.
    • Apply air pressure to the hole in the drum to remove the coast clutch piston while blocking the other hole with a finger.
scientia non olet · About LEMON Manuals