LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 556 (Automatic Transmission) >> Disassembly And Assembly Of Subassemblies >> Forward Clutch >> Item 7: Forward Clutch Piston Disassembly Note

Item 7: Forward Clutch Piston Disassembly Note

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Air pressure must not exceed 138 kPa (20 psi). Wear safety glasses when using compressed air. Make sure the cylinder is facing down as shown. Failure to follow these instructions may result in personal injury.
    Fig 1: Removing Forward Clutch Piston
    G03182225Courtesy of FORD MOTOR CO.
  1. Remove the forward clutch piston.
    1. Place the forward clutch cylinder with forward clutch piston facing down.
    2. Install the center support on the forward clutch cylinder.
    3. Apply air pressure to the left port of the center support.
scientia non olet · About LEMON Manuals