LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 556 (Automatic Transmission) >> Diagnosis And Testing >> Torque Converter Diagnosis >> Torque Converter Operation Test

Torque Converter Operation Test

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Carry out the Quick Test. See ON-BOARD DIAGNOSTICS WITH NGS . Refer to DIAGNOSTICS . Check for DTCs. Refer to the DIAGNOSTIC TROUBLE CODE CHARTS .
  2. Connect a tachometer to the engine.
  3. Bring the engine to normal operating temperature by driving the vehicle at highway speeds for approximately 15 minutes in (D) position.
  4. After normal operating temperature is reached, maintain a constant vehicle speed of about 80 km/h (50 mph) and tap brake pedal with the left foot.
  5. The engine rpm should increase when the brake pedal is tapped and decrease about 5 seconds after the pedal is released. If this does not occur, refer to Torque Converter Operation Concerns in DIAGNOSIS BY SYMPTOM .
  6. If the vehicle stalls in (D) or MANUAL 2 at idle with vehicle at a stop, move the transmission range selector lever to MANUAL 1 position. If the vehicle stalls, refer to DIAGNOSIS BY SYMPTOM  . Repair as necessary. If the vehicle does not stall in (D), refer to DIAGNOSIS BY SYMPTOM .
scientia non olet · About LEMON Manuals