General Specifications
WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Lubricants and Chemicals | |
| SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP or equivalent | WSS-M2C153-H |
| Motorcraft Silicone Brake Caliper Grease and Dielectric Compound XG-3 or equivalent | ESE-M1C171-A |
| High Temperature Nickel Anti-Seize Lubricant XL-2 (in Canada CXG-2) or equivalent | ESE-M12A4-A |
| Penetrating and Lock Lubricant XL-1 or equivalent | - |
| Starting System | |
| Normal engine cranking speed | 140-220 rpm |
| Starter motor armature shaft maximum runout | 0.11 mm (0.005 in) |
| Starter motor brush manufactured length | 16.8 mm (0.66 in.) |
| Starter motor brush spring tension | 18 N (64 oz) |
| Starter motor commutator maximum runout | 0.12 mm (0.005 in) |
| Starter motor diameter | 101.6 mm (4.0 in.) |
| Starter motor maximum load | 800 amps |
| Starter motor minimum stall torque (at 5 volts) | 14.7 Nm (10.8 lb-ft) |
| Starter motor no load current draw | 60-80 amps |
| Starter motor normal load current draw | 130-220 amps |
| Starter circuit maximum voltage drop (engine at normal operating temperature) | 0.5 volts |
| Engine Ignition | |
| Base timing | 10° BTDC |
| Firing order | 1-3-7-2-6-5-4-8 |
| Spark plug gap | 1.32-1.42 mm (0.052-0.056 in.) |
| Spark plug | AGSF32P |