LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 555 (Intake Air System, Fuel Charging System & Engine Electronics System-4.6L (2V) Engine) >> Removal And Installation >> Camshaft Position (CMP) Sensor >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Camshaft Position (CMP) Sensor Special Tool
G03181878Courtesy of FORD MOTOR CO.
  1. Disconnect the battery ground cable. For additional information, Refer to BATTERY DISCONNECT
  2. Remove the drive belt. For additional information, Refer to ENGINE - 4.6L (2V) .
  3. Remove the components in the order indicated in the following illustration and table.
    Fig 2: Identifying Camshaft Position (CMP) Sensor Components
    G03181879Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure. Fill the power steering system. For additional information, Refer to STEERING SYSTEM
scientia non olet · About LEMON Manuals