LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 551 (Engine - 4.0L) >> In-Vehicle Repair >> Camshaft, Valve Springs and Valve Seals - RH >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH and RH valve covers. For additional information, refer to VALVE COVER LH  and VALVE COVER RH .
    2. NOTE: This step is necessary for camshaft removal only.
  2. Remove the cooling fan. For additional information, refer to ENGINE COOLING .
  3. Remove the parts in the order indicated in the following illustration and table.

    To remove individual parts, only carry out the listed steps: 

    BEARING SPECIFICATIONS

    Part Steps
    Valve springs 2-5
    Valve seals 2-6
    Camshafts 1, 2, 7-12
    Fig 1: Removing Camshaft, Valve Springs and Valve Seals - RH
    G03180578Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals