LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 551 (Engine - 4.0L) >> In-Vehicle Repair >> Camshaft Roller Follower and Hydraulic Lash Adjuster >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH and RH valve covers. For additional information, refer to VALVE COVER LH  or VALVE COVER RH .
  2. Remove the fuel rail. For additional information, refer to INTAKE AIR, FUEL CHARGING, STARTING AND ENGINE ELECTRONICS - 4.0L SOHC .
  3. Remove the cooling fan. For additional information, refer to ENGINE COOLING .
  4. Remove the parts in the order indicated in the following illustration and table.
    Fig 1: Removing Camshaft Roller Follower and Hydraulic Lash Adjuster
    G03180594Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals