LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Starting System - F150 Pickups) >> Removal & Installation >> Digital Transmission Range Sensor >> Installation

Digital Transmission Range Sensor: Installation

WARNING: This page is about a different car, the 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Install DTR sensor and finger tighten 2 bolts. Ensure transmission is in Neutral. Using DTR sensor Adjusting Gauge (307-351), align DTR sensor. See Figure. Tighten bolts to specification. See TORQUE SPECIFICATIONS . Reconnect shift cable and electrical connector.



  1. Install the DTR sensor and loosely install the bolts. Manual shift lever must be in the neutral position. Using the special tool, align the DTR sensor slots. The tool is designed to fit snug. Tighten the bolts to specification. See TORQUE SPECIFICATIONS .
  2. Install and position the manual control lever. Install a new manual lever shaft outer nut and torque to specification. With the manual lever in overdrive connect the shift lever control cable. Install the DTR sensor electrical connector. Lower the vehicle. Connect the battery ground cable.
scientia non olet · About LEMON Manuals