LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 547 (Brake System) >> Removal And Installation >> Parking Brake >> Item 1: Pin Removal Note

Item 1: Pin Removal Note

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH A-pillar lower trim panel. For additional information, REFER to BODY SYSTEM - INTERIOR .
  2. With an assistant, release the parking brake cable tension by pulling down on the intermediate cable at the cable union until the parking brake control sector rotates to its stop and a 4 mm (5/32 inch) x 150 mm (5.9 inch) retainer pin can be inserted.
  3. Disconnect the cable union.
    Fig 1: Disconnecting Cable Union
    G03180243Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals