LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 547 (Brake System) >> Removal And Installation >> Parking Brake >> Item 1: Pin Installation Note

Item 1: Pin Installation Note

WARNING: This page is about a different car, the 2004 Mercury Mountaineer and 2004 Ford Explorer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the cable union.
  2. With an assistant, release the parking brake cable tension by pulling down on the intermediate cable at the cable union until the parking brake control sector pressure is released, remove the pin.
  3. Install the A-pillar lower trim panel. For additional information, REFER to BODY SYSTEM - INTERIOR .
scientia non olet · About LEMON Manuals