Replacement Of The Weld Nut And Reinforcement
WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
- Expose the suspect anchor point.
- Drill out two 8 mm (5/16 inch) diameter access holes adjacent to the weld nut clearance hole.
- Thread a length of copper welding wire through the clearance hole and position to secure the weld nut and washer.
- Use MIG wire feed welder and plug weld a 7/16 inch weld nut and standard washer in place at the two 8 mm (5/16 inch) holes.
- Metal finish as necessary.
- Install the restraint system.
- Carry out the Functional Test. For additional information, refer to SAFETY BELT SYSTEM .
NOTE:
If the B-, C- or D-pillar safety belt anchor nuts or reinforcements are stripped or missing, a new nut/reinforcement plate must be installed.