LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Sliding Door Handles >> Notes

Sliding Door Handles: Notes

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Special Tool(s)
G03247057Courtesy of FORD MOTOR CO.
MATERIAL SPECIFICATION

Item Specification
Multi-Purpose Grease Spray XL-5 ESB-M1C93-B
NOTE: Right side shown, left side similar.
  1. Remove the sliding door trim panel. For additional information, refer to BODY SYSTEM - INTERIOR .
  2. Remove parts in the order indicated in the following illustration and table.

    To remove individual parts, only carry out the listed steps: 

    Part Steps
    Exterior sliding door handle 16, 17
    Interior sliding door handle 14, 15
    Sliding door lock actuator 1-7, 12, 13
    Sliding door detent switch 1, 7-9
    Sliding door latch actuator 1-7, 10, 11
    Sliding door remote control 1-7
    Fig 2: Removing Sliding Door Handle(s)/Components
    G03247058Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.