LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 541 (Handles, Locks, Latches And Entry Systems) >> General Procedures >> Autolock and Horn Chirp Programming >> Using The Ignition Lock Cylinder

Using The Ignition Lock Cylinder

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Close all doors.
  2. Confirm that the key is in the OFF position.
  3. Turn the key from OFF to ON.
    4. NOTE: Steps 4 through 8 must be carried out within 30 seconds.
  4. Press the door lock control switch UNLOCK button 3 times.
  5. Turn the key from ON to OFF.
  6. Press the door lock control switch UNLOCK button 3 times.
  7. Turn the key from OFF to ON.
  8. Verify that the horn chirps. This indicates the system is in the enable/disable mode and is ready to accept program changes.
  9. Press the door lock control switch UNLOCK button once, then the LOCK button once to toggle the autolock/relock feature OFF.
  10. Verify that the horn chirps one time. There should be only one chirp indicating that autolock/relock feature has been disabled. If one chirp is heard, followed by a longer sound of the horn, the autolock/relock feature has just been enabled. Return to step 9.
  11. Turn the key to the OFF position to exit the enable/disable mode.
  12. Exit the vehicle and verify that the horn chirps once to indicate that a feature has been changed and that autolock/relock has been disabled.
scientia non olet · About LEMON Manuals