LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 540 (Seat System) >> Disassembly And Assembly >> Front Seat Cushion - Driver >> Item 10: Seat Side Air Bag Connector Disassembly Note

Item 10: Seat Side Air Bag Connector Disassembly Note

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and detach the seat side air bag connector and route through the seat cushion frame for backrest removal, noting the route for installation.
  2. Detach and disconnect the backrest TED electrical connector and disconnect the backrest climate controlled seat duct from the climate controlled blower for backrest removal.
    Fig 1: Disconnecting Backrest TED Electrical Connector
    G03246946Courtesy of FORD MOTOR CO.
  3. If equipped, disconnect the three memory seat motor position sensors electrical connectors and release any pin-type retainers attached to the seat cushion pan.
    4. NOTE: Disconnect and release any remaining electrical connectors and pin-type retainers attached to the seat cushion and pan assembly.
  4. Disconnect the two heated seat cushion element electrical connectors from the backrest heated seat element.
scientia non olet · About LEMON Manuals