LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Disc Brakes & Drum Brakes) >> Adjustments >> Stoplight Switch

Stoplight Switch

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check and adjust brake pedal height as necessary. See BRAKE PEDAL HEIGHT  .
  2. Disconnect the battery ground cable.
  3. Adjust the Brake Pedal Position (BPP) switch. Disconnect the harness connector. Loosen the lock nut. Adjust the BPP switch. Measure distance from brake pedal stopper to threaded end of stoplight switch. See Fig 1 . Switch height "A" should be 0.012-0.039" (0.30-1.00 mm).
  4. Tighten the lock nut. Reconnect the harness connector.
  5. Reconnect the battery ground cable.
Fig 1: Adjusting Stoplight & Cruise Control Deactivator Switches
G93D76466Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals