Brake Load Sensor Proportioning Valve

WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: All fluids should be at specified levels (fuel tank full) and spare tire, jack, hand tools and floor mats should be in their stowed positions.

Measure spring length with vehicle in unloaded position. Spring length "A" should measure 6.25-6.37" (158.8-161.8 mm). See Fig 1 .
If the spring length is not within specifications, loosen the eye bracket bolts and adjust the spring length to the specified length.
Adjust spring length by moving bracket. See Fig 2 . Tighten eye bracket bolts to specification. See TORQUE SPECIFICATIONS .

Fig 1: Measuring Brake Load Sensor Proportioning Valve Spring Length

Courtesy of FORD MOTOR CO.

Fig 2: Adjusting Brake Load Sensor Valve Spring Length

Courtesy of FORD MOTOR CO.