Removal & Installation: Condenser: Installation
WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedure. Add 1 ounce (30 ml) of clean PAG Refrigerant Compressor Oil or equivalent to A/C condenser or accumulator-drier inlet tube. Use new "O" rings lubricated with clean refrigerant oil. Evacuate, charge, and leak test A/C system. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING.