Removal & Installation: Accumulator-Drier: Installation
WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. If a new accumulator is to be installed, transfer A/C cycling switch to new accumulator-drier. Add a quantity of new oil to match that drained from old accumulator-drier plus 2 ounces (60 ml) of clean PAG Refrigerant Compressor Oil or equivalent.
- Install new "O" ring seals lubricated in clean PAG oil or equivalent. Evacuate, leak test, and charge refrigerant system. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING.