LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 526 (Automatic Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routine 201/301 - Egagement Concern: No Forward

Diagnostic Routine 201/301 - Egagement Concern: No Forward

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
ENGAGEMENT CONCERN: NO FORWARD

Possible Component Reference/Action
201 - ELECTRICAL ROUTINE 
Powertrain Control System 
  • No electrical concerns
  • If DTC P1700 is present check for a low transmission fluid level, then continue to Hydraulic/Mechanical Routines.
301 - HYDRAULIC/MECHANICAL ROUTINE 
Shift Linkage 
  • Damaged or out of adjustment
Incorrect Pressures 
  • Low forward clutch pressure, low line pressure, low EPC pressure
  • Check pressure at line and EPC taps. Carry out Line Pressure Tests And Stall Speed Tests. Refer to SPECIAL TESTING PROCEDURES . See the LINE PRESSURE CHART  for specification. If pressures are low, check the following possible components:
    • Main control valve body
    • Pump assembly
    • Low intermediate clutch assembly
    • Low intermediate apply tube and seal, N-D accumulator assembly
Main Control Valve Body 
  • Bolts out of torque specification
  • Adjust bolts to specification.
  • Gaskets and Separator Plate - damaged, off location
  • Inspect gaskets for damage. Install new as required.
  • Manual Control Valve - damaged
  • Inspect. Repair as required.
Pump Assembly 
  • Bolts out of torque specification
  • Adjust bolts to specification.
  • Gaskets and Separator Plate - damaged, off location
  • Inspect for damage. Install new as required.
  • Porosity/cross leaks/ball missing or leaking
  • Inspect for porosity and leaks. Install new as required.
.
  • Components - damaged
  • Inspect for damage. Install new as required
Low/Intermediate One-Way Clutch Assembly 
 
  • DTC P1700 present
  • Worn, damaged, misassembled
  • Inspect for damage. Repair as required.
  • Roller - damaged
  • Inspect for damage. Repair as required.
  • Case - damaged
  • Inspect for damage. Repair as required.
  • Springs - damaged
  • Inspect for damage. Repair as required.
  • Inner/Outer Races - damaged
  • Inspect for damage. Repair as required.
Low/Intermediate Clutch Assembly 
  • Seals, Piston - damaged
  • Fluid Tubes and Seals - worn, damaged, loose, leaking
  • Inspect. Install new as required.
  • Friction Elements - damaged, clearance check incorrect
  • Inspect. Repair as required.
  • Wave Spring - damaged, missing
  • Inspect. Repair as required.
Low/Intermediate Accumulator Assembly 
  • Piston Seals - damaged, leaking
  • Shaft or Bore - damaged, leaking
  • Inspect for damage. Repair as required.