LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 524 (Engine Cooling System) >> Removal And Installation >> Thermostat And Thermostat Housing >> Item 3: Thermostat Housing-to-Engine Bolts Installation Note

Item 3: Thermostat Housing-to-Engine Bolts Installation Note

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Tighten the thermostat housing-to-engine bolts in two stages.
    • Stage 1: Tighten to 8 Nm (71 lb-in).
    • Stage 2: Tighten an additional 60 degrees.
scientia non olet · About LEMON Manuals