LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 522 (Engine System-General Information) >> General Procedures >> Cylinder Bore - Out-of-Round

Cylinder Bore - Out-of-Round

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure the cylinder bore in two directions. The difference is the out-of-round. Verify the out-of-round is within the wear limit and bore the cylinder to the next oversize limit.
Fig 1: Measuring Cylinder Bore - Out-Of-Round
G03243740Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals