LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 518 (Suspension System) >> General Procedures >> Wheel Alignment >> Front And Rear Wheel Bearing Inspection

Front And Rear Wheel Bearing Inspection

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle until the tire is off the floor. For additional information, refer to IDENTIFICATION CODES .
  2. Grasp each front tire at the top and bottom and move the wheel inward and outward while lifting the weight of the tire off the wheel bearing.
  3. If the tire and wheel (hub) is loose or does not rotate freely, install a new front or rear wheel hub and bearing assembly. For additional information, refer to WHEEL BEARING, WHEEL HUB, WHEEL KNUCKLE, AND LOWER ARM - FRONT  or REAR SUSPENSION .
scientia non olet · About LEMON Manuals