Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the BPP switch electrical connector.

Fig 1: Disconnecting BPP Switch Electrical Connector
Courtesy of FORD MOTOR CO.
Remove the BPP switch assembly
1. Remove the self-locking pin.
2. Remove the spacer.
3. Remove the BPP switch.
  
  Fig 2: Removing BPP Switch Assembly
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.