LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 500 (Exterior Lighting System) >> Diagnosis And Testing >> Turn Signal and Hazard Lamps >> Pinpoint Tests >> Pinpoint Test K: One Turn Signal/Hazard Lamp Is Always On

Pinpoint Test K: One Turn Signal/Hazard Lamp Is Always On

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. K1 CHECK THE STOPLAMPS 
    • Press and release the brake pedal while observing the rear lamps.
    • Do the stoplamps operate correctly? 
    1. Yes  : GO to K2.
    2. No  : REFER to STOPLAMPS .
  2. K2 CHECK CIRCUITS 2 (WH/LB) (RH) AND 3 (LG/WH) (LH) FOR SHORTS TO POWER 
    • Key in OFF position.
    • Disconnect: Multifunction Switch C202a.
    • Key in ON position.
    • Does the turn/hazard lamp continue to illuminate? 
    1. Yes  : INSTALL a new multifunction switch. REFER to STEERING COLUMN SWITCHES . TEST the system for normal operation.
    2. No  : For the LH front parking/turn lamp, REPAIR circuit 3 (LG/WH). TEST the system for normal operation.

      For the RH front parking/turn lamp, REPAIR circuit 2 (WH/LB). TEST the system for normal operation.

scientia non olet · About LEMON Manuals