Removal & Installation: Condenser: Installation
WARNING: This page is about a different car, the 2002 Mercury Villager. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Add one oz (30 ml) of clean PAG refrigerant compressor oil or equivalent to condenser or accumulator-drier inlet tube. Use new "O" rings lubricated with clean refrigerant oil. Evacuate and recharge the A/C system. See RECOVERY, EVACUATION & RECHARGING in GENERAL SERVICING PROCEDURES article in GENERAL SERVICING.
- Lubricate coolant hoses with coolant hose lubricant or plain water only if needed. Fill and bleed cooling system. Check system for proper operation.