LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 486 (Acceleration Control System) >> Removal And Installation >> Pedal - Accelerator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2004 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the accelerator cable (9A758) from the accelerator pedal and shaft (9725).
    Fig 1: Disconnecting Accelerator Cable (9A758) From Accelerator Pedal And Shaft (9725)
    G03276568Courtesy of FORD MOTOR CO.
  2. Remove the bolt and remove the accelerator pedal and shaft.
    Fig 2: Removing Accelerator Pedal And Shaft
    G03276569Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals